SKU# PP-256SI
| IGBT Inverter Type: | IGBT |
| Voltage/phase: | 220/240 V 1 PHASE |
| TIG output type: | AC/DC |
| TIG Start Type: | High Frequency Only |
| Pulse: | Y A |
| Plasma Cutter Arc Start Type: | Blow Back (Piston type) |
| PilotArc: | Yes |
| OK-to-Cut Indicator/Low Air pressure safety: | Yes |
| AC Frequency: | 20-250 Hz |
| AC Balance (cleaning): | 10-90% |
| OCV: | 85V |
| Max Inrush ( I1MAX ) Amps: | 40A |
| Maximum Rated (I1EFF ) Input Amps: | 32A |
| TIG Output Amps/Volts @ Rated Duty Cycle: | 2 2 |
| Stick Output Amps/Volts @ Rated Duty Cycle: | 2 1 1 |
| Plasma Output Amps/Volts @ Rated Duty Cycle: | 6 5 4 |
| TIG AC Amp/Volt Range: | 20A-250A; 10.8V-20V |
| TIG DC Amp/Volt Range: | 5A-250A; 10.2V-20V |
| Stick Amp/Volt Range: | 5A-200A; 20.2V-28V |
| Plasma Amp/Volt Range: | 20A-60A; 88V-104V |
| Start Amps: | D A |
| End Amps: | D A |
| Down Slope Time: | 0-25 Seconds |
| Up Slope Time: | 0-10 Seconds |
| Preflow time: | 0-10 Seconds |
| Post Flow Time: | 0-25 Seconds |
| OverCurrent Protection: | Yes |
| Duty Cycle Protection: | Yes |
| Air Pressure OK Safety Indicator: | Yes |
| TIG Pulse Frequency: | .5-250Hz |
| TIG Pulse Time On: | 10-90% |
| TIG Pulse Amp Range: | 5-95% |
| Stick Arc Force Control: | Yes, 10-100% |
| Torch Type: | PT/iPT 60 |
| Recommended Cutting Air Pressure: | 75 PSI |
| Recommended Compressor Capacity: | 6 CFM @ 90 PSI, 20 Gallon |
Downloads